Getting started

Coil installation and powering on

  1. Loosen both screws on the top door with a small Phillips or flat-head screwdriver (do not remove them, just loosen).
  2. Insert the coil, making sure the center post goes into the right terminal and the coil is seated properly.
  3. Gently tighten the screws to secure the coil (do not overtighten).
  4. Press the button 5 times to turn the device on.
  5. Once powered on, the Bubblr is ready to use.
  6. Load, Press and Enjoy

Each Bubblr is tested prior to shipping, but battery may need to be charged before your first puff.

How -To

  1. Loosely fill the bowl to the top. Avoid packing too tightly, since airflow through the bowl is important for performance.
  2. Hold the button for roughly six seconds to begin heating.
  3. Watch for a visual cue that the device is ready—either visible smoke or the glow of the coil through the hole in the top door.
  4. While inhaling, keep the button held to maintain heat through the draw, then release it when the pull is complete.
  5. Repeat the process as needed until the bowl is finished.

Cleaning & Care

  1. Remove the magnetic mouthpiece.
  2. Remove the bowl door and bowl.
  3. Remove the coil.
  4. Soak the bowl door and bowl in isopropyl alcohol.
  5. Add isopropyl alcohol and salt to the main chamber.
  6. Plug the down stem and mouthpiece openings and shake well.
  7. Use a cotton swab with isopropyl alcohol to clean the down stem, top door, bowl door, and bowl.
  8. Carefully rinse all parts with water
    (the Bubblr is sealed but not fully waterproof).
  9. For best performance, clean the device regularly rather than waiting for heavy buildup.